LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Wiring Systems (General Information) >> Repair Instructions >> Relay Replacement (Attached To Wire Harness) >> Removal Procedure

Removal Procedure

  1. Locate the relay attached to wire harness. See BUZZERS, RELAYS & TIMERS in ELECTRICAL COMPONENT LOCATOR article.
  2. Remove any fasteners which hold the relay in place.
  3. Remove any connector position assurance (CPA) devices or secondary locks.
    IMPORTANT: Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape.
  4. Separate the relay (1) from the wire harness connector (2).
    Fig 1: Locating Relay Attached To Wire Harness
    G01840710Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals