LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Rear Oil Seal and/or Bearing Replacement >> Removal Procedure

Removal Procedure

  1. Raise the vehicle. Refer to LIFTING & JACKING THE VEHICLE in General Information.
  2. Remove the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
  4. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
  5. For axles with drum brakes, remove the axle shaft seal and the bearing from the axle housing using the J 22813-01  (7.6 inch axle) or the J 23689  (8.6 inch axle) (1) and the J 2619-01  (2).
    Fig 1: Removing Axle Shaft Seal And Bearing From Axle Housing Using J 22813-01/J 23689 And J 2619-01 (Axles With Drum Brakes)
    G01670936Courtesy of GENERAL MOTORS CORP.
  6. For axles with disc brakes, remove the axle shaft seal and the bearing from the axle housing using the J 22813-01  (7.6 inch axle) or the J 23689  (8.6 inch axle) (1) and the J 2619-01  (2).
    Fig 2: Removing Axle Shaft Seal And Bearing From Axle Housing Using J 22813-01/J 23689 And J 2619-01 (Axles With Disc Brakes)
    G01670937Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals