LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Rear Drive Axle >> Repair Instructions >> Differential Side Bearings Replacement >> Installation Procedure

Installation Procedure

  1. Install the differential side bearings by doing the following:
    1. In order to protect the differential case, install the J 8107-2  (2) in the case on the side opposite the bearing installation.
    2. Install the J 25299  (2) and the J 8092  (1) onto the differential case bearing as shown.
    3. Drive the bearing onto the case using the J 25299  (2) and the J 8092  (1).
  2. Install the differential. Refer to Differential Replacement .
    Fig 1: Installing J 25299 And J 8092 Onto Differential Case Bearing
    G01670959Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals