LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Front Drive Axle - 4WD >> Overhaul >> Right Axle Shaft Housing Assembly >> Disassembly

Right Axle Shaft Housing Assembly: Disassembly

  1. Remove right axle shaft & housing. See RIGHT AXLE SHAFT & HOUSING  under REMOVAL & INSTALLATION. Place mounting flange of axle housing assembly in a vise. Remove springs, shift fork, and differential sleeve. Remove snap ring, connector gear and thrust washer from axle shaft.
  2. Using a soft mallet, tap on flange end of axle shaft to remove axle shaft from housing. DO NOT hammer on pilot bearing stem end of axle shaft, severe damage will result. Using a screwdriver, pry out oil seal.
  3. Using a Bearing Remover (J-29369-2) and slide hammer, remove axle bearing from housing.
scientia non olet · About LEMON Manuals