LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim >> Repair Instructions >> Molding Replacement - Rocker Panel (Blazer) >> Removal Procedure

Removal Procedure

  1. Remove the front fender lower rocker panel molding.
  2. Remove the push pin retainer.
    Fig 1: Rocker Panel Molding (Blazer)
    G01841224Courtesy of GENERAL MOTORS CORP.
  3. Remove the screw from the rear wheel opening.
  4. Carefully lift up on the rocker panel molding in order to remove the rocker panel molding from the vehicle.
scientia non olet · About LEMON Manuals