LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Bumper System >> Repair Instructions >> Filler Panel Replacement - Rear Bumper (Utility Vehicles W/Liftgate) >> Removal Procedure

Removal Procedure

  1. Remove the license plate lamp harness. Refer to LICENSE LAMP REPLACEMENT (W/ STEP BUMPER) , LICENSE LAMP REPLACEMENT (W/O STEP BUMPER) or LICENSE LAMP REPLACEMENT (FILLER PANEL) in EXTERIOR LIGHTS article.
  2. Remove the bumper filler panel by pulling the retaining clips out of the body.
  3. Remove the bumper filler panel from the vehicle.
    4. Fig 1: Locating Rear Bumper Filler Panel (Utility Vehicles W/Liftgate)
    G01841347Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals