LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Strut Replacement - End Gate >> Removal Procedure

Removal Procedure

  1. Open and support the endgate.
    NOTE: Refer to LIFTGATE ASSIST ROD NOTICE in GM VEHICLES CAUTIONS & NOTICES article.
  2. Lift up the retainer clips on the endgate struts using a small flat-bladed tool.
  3. Remove the upper end of the endgate struts from the ball joint.
    Fig 1: Locating Endgate Struts Ends
    G01841849Courtesy of GENERAL MOTORS CORP.
  4. Remove the lower end of the endgate struts from the ball joint.
  5. Remove the endgate struts from the endgate.
scientia non olet · About LEMON Manuals