LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> PULLSTRAP Replacement - Lift Gate >> Installation Procedure

Installation Procedure

  1. Install the liftgate assist handle to the liftgate trim panel.
    NOTE: Refer to FASTENER NOTICE in GM VEHICLES CAUTIONS & NOTICES article.
  2. Install the screw that retains the liftgate assist handle to the liftgate trim panel.

    Tighten 

    Tighten the screw to 1.9 N.m (17 lb in).

    Fig 1: Locating Liftgate Assist Handle
    G01841813Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals