LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Body Rear End >> Repair Instructions >> Lock Striker Replacement - End Gate (Pickup) >> Installation Procedure

Installation Procedure

  1. Install the pickup box endgate striker to the vehicle.
  2. Install the nuts that retain the pickup box endgate striker to the vehicle.
    NOTE: Refer to FASTENER NOTICE in GM VEHICLES CAUTIONS & NOTICES article.
  3. Install the bolts that retain the pickup box endgate striker to the vehicle.

    Tighten 

    Tighten the bolts to 25 N.m (18 lb in).

    Fig 1: Locating Pickup Box Endgate Striker (Pickup)
    G01841894Courtesy of GENERAL MOTORS CORP.
  4. Connect the pickup box endgate cable to the endgate striker bolt.
  5. Install the tail lamp. Refer to TAIL LAMP REPLACEMENT (PICKUP) or TAIL LAMP REPLACEMENT (UTILITY) in EXTERIOR LIGHTS article.
scientia non olet · About LEMON Manuals