LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting Systems >> Repair Instructions >> High Mounted Stop Lamp Replacement (Utility - ENDGATE Window) >> Installation Procedure

Installation Procedure

  1. Connect the electrical connector and push the connector through the hole in the body in order to install the electrical connector.
  2. Insert the rubber grommet into the hole in order to ensure that the hole is properly seated.
  3. Install the high mount stop lamp to the vehicle.
    NOTE: Refer to FASTENER NOTICE in GM VEHICLES CAUTIONS & NOTICES article.
  4. Install the screws that retain the high mount stop lamp to the endgate window.

    Tighten 

    Tighten the high mount stop lamp screws to 2.5 N.m (22 lb in).

    Fig 1: Locating High Mount Stop Lamp Components (Utility - Endgate Window)
    G01842806Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals