LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> Steering >> Steering Wheel & Steering Column >> Repair Instructions >> Ignition & Key Alarm Switch Assembly - Assemble - Off Vehicle

Ignition & Key Alarm Switch Assembly - Assemble - Off Vehicle

  1. Install the ignition and key alarm switch assembly (3) onto the electronic lock module assembly (2).
  2. Install the 2 tapping screws into the ignition and key alarm switch assembly (3).
  3. Tighten the screws to 1.5 N.m (13 lb in).
  4. Install the key alarm connector (1) to the electronic lock module assembly (2)
  5. Slide the 2 connectors (2) onto the bulk head connector (1).
  6. Install the wire harness strap (2) into the steering column tilt head assembly (1).
  7. Install the wire harness straps (3) onto the wire harness assembly (4).
  8. Install the wire harness assembly (4) into the wire harness strap (5).
  9. Install the upper and lower trim covers.
  10. Enable the inflatable restraint steering wheel module. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM .
scientia non olet · About LEMON Manuals