LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 829 (Engine Mechanical - 4.3L) >> Repair Instructions >> On-Vehicle Repair Instructions >> Valve Rocker Arm Cover Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the valve rocker arm cover and bolts. Refer to VALVE ROCKER ARM COVER INSTALLATION - LEFT  .
  2. Install the PCV valve hose assembly to the intake manifold and in the valve rocker arm cover.
    Fig 1: Installing PCV Valve Hose Assembly To Intake Manifold And In Valve Rocker Arm Cover - Left
    G01643677Courtesy of GENERAL MOTORS CORP.
  3. Install the rear spark plug wire retainer to the support.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the oil filler tube and bolt.
    Fig 2: Installing Oil Filler Tube And Bolt - Left
    G01643678Courtesy of GENERAL MOTORS CORP.

    Tighten 

    Tighten the bolt to 25 N.m (18 lb ft).

  5. Connect the ECT sensor electrical connector.
    Fig 3: Connecting ECT Sensor Electrical Connector - Left
    G01643679Courtesy of GENERAL MOTORS CORP.
  6. Install the engine cover. Refer to ENGINE COVER REPLACEMENT in Interior Trim.