Removal Procedure
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to ENGINE MOUNTING NOTICE
in Cautions and Notices.
- Disconnect the battery negative cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Battery
- Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
- Remove the right front tire. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
- Remove the right fender wheelhouse extension. Refer to WHEELHOUSE EXTENSION REPLACEMENT in Body Front End.
- Remove the starter. Refer to STARTING SYSTEM in Battery.
- Remove the engine mount through-bolt and nut.
NOTE: Refer to ENGINE LIFTING NOTICE in Cautions and Notices.
- Using a jack on the square tab (left side shown) at the rear of the engine block, raise the engine only enough to remove the engine mount.
- Remove the bolts for the engine mount bracket to the engine.
Access the upper two bolts for the right engine mount bracket through the fender wheelhouse.
- Remove the engine mount bracket.
- For AWD vehicle remove the bolts for the engine mount to the frame (left side shown).
- Remove the engine mount.
- For a RWD vehicle right side remove the bolts and the nuts for the engine mount to the frame.