Cylinder Head Removal - Left

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

Remove the engine coolant temperature sensor, if applicable.

Fig 1: Removing Engine Coolant Temperature Sensor - Left
Courtesy of GENERAL MOTORS CORP.
Remove the engine coolant temperature gage sensor, if applicable.

Fig 2: Removing Engine Coolant Temperature Gage Sensor - Left
Courtesy of GENERAL MOTORS CORP.
Remove the spark plugs

Fig 3: Removing Spark Plugs - Left
Courtesy of GENERAL MOTORS CORP.
Remove the bolts and the spark plug wire support.

Fig 4: Removing Bolts And The Spark Plug Wire Support - Left
Courtesy of GENERAL MOTORS CORP.
Remove the cylinder head bolts.

Fig 5: Removing Cylinder Head Bolts - Left
Courtesy of GENERAL MOTORS CORP.

NOTE: After removal, place the cylinder head on two wood blocks to prevent damage.
Remove the cylinder head.

Fig 6: Removing Cylinder Head - Left
Courtesy of GENERAL MOTORS CORP.
Remove and discard the cylinder head gasket.

Fig 7: Removing Discard Cylinder Head Gasket - Left
Courtesy of GENERAL MOTORS CORP.
Remove the cylinder head locator dowel pins, if required.

Fig 8: Removing Cylinder Head Locator Dowel Pins - Left
Courtesy of GENERAL MOTORS CORP.