Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new speed sensor and O-ring seal using J 38417.
- Coat the seal with a thin film of transmission fluid.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the bolt.
Tighten
Tighten the bolt to 11 N.m (97 lb in).
- Install the harness connector.
- Lower the vehicle.
- Refill the fluid as required.