LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 826 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power steering cooler pipe to the vehicle.
  2. Install the power steering cooler pipe (2) to the air baffle (3).
    Fig 1: Installing Power Steering Cooler Pipe To Air Baffle
    G01645886Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Connect the power steering cooler pipe to the steering gear.
    Fig 2: Connecting Power Steering Cooler Pipe To Steering Gear
    G01645887Courtesy of GENERAL MOTORS CORP.

    Tighten 

    Tighten the power steering cooler pipe to the steering gear to 27 N.m, (20 lb ft).

  4. Lower the vehicle.
  5. Connect the power steering cooler hose to the steering pump.
  6. Bleed the power steering system. Refer to BLEEDING THE POWER STEERING SYSTEM .
scientia non olet · About LEMON Manuals