LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 823 (Seat System) >> Repair Instructions >> Seat Riser Trim Cover Replacement - Power >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the power seat switch to the trim plate by snapping the switch into place.
  2. Connect the power seat switch electrical connector.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the screws that retain the power seat trim plate to the cover.

    Tighten 

    Tighten the screws that retain the power seat trim plate to the cover to 2 N.m (18 lb in).

  4. Install the seat bolts to the seat riser.

    Tighten 

    Tighten the riser to seat retaining bolts to 30 N.m (22 lb ft).

  5. Install the seat riser trim cover.
  6. Install the screws to seat riser trim cover.

    Tighten 

    Tighten the screws to seat riser trim cover to 2 N.m (18 lb in).

    Fig 1: Installing Screws Retaining Power Seat Trim Plate To Cover
    G01567113Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals