LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 823 (Seat System) >> Repair Instructions >> Seat Back Hinge Trim Replacement - Rear Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the upper seat back hinge cover as follows:
    1. 1.1. Align the fasteners with the hinge.
    2. 1.2. Press the lower seat back hinge cover into place.
      Fig 1: Identifying Lower Seat Back Hinge Cover
      G01567184Courtesy of GENERAL MOTORS CORP.
  2. Install the lower seat back hinge cover as follows:
    1. 2.1. Align the fasteners with the hinge.
    2. 2.2. Press the upper seat back hinge cover into place.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the lower seat back hinge cover retaining screw.

    Tighten 

    Tighten the lower seat back hinge cover retaining screw to 2 N.m (18 lb in).

  4. Install the rear bench seat to the vehicle. Refer to SEAT REPLACEMENT - REAR BENCH  .
    Fig 2: Identifying Upper Seat Back Hinge Cover
    G01567185Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals