LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 823 (Seat System) >> Repair Instructions >> Seat Adjuster Mechanism Replacement - Power >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat trim panel L bracket flanges between the adjuster and the seat.

    Ensure that the holes in the L bracket flanges are indexed with the fastener holes on the adjuster and the seat.

  2. Connect the electrical connector on the back of the power seat switch.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 4 bolts that retain the adjuster to the seat.

    Tighten 

    Tighten the bolts that retain the adjuster to the seat to 30 N.m (22 lb ft).

  4. Position the riser to the adjuster.
  5. Install the 8 nuts that retain the riser to the adjuster.

    Tighten 

    Tighten the nuts that retain the adjuster to the seat to 9 N.m (7 lb ft).

    Fig 1: Installing Adjuster To The Seat
    G01567119Courtesy of GENERAL MOTORS CORP.
  6. Install the seat to the vehicle. Refer to SEAT REPLACEMENT - BUCKET  .
scientia non olet · About LEMON Manuals