Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

Install the parking brake release lever to the knee bolster.
Install the knee bolster:
1. 2.1. Align the retainers.
2. 2.2. Press the panel into place.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the screws that retain the knee bolster to the instrument panel.

Fig 1: Installing Screws That Retain Knee Bolster To Instrument Panel
Courtesy of GENERAL MOTORS CORP.

Tighten

Tighten the knee bolster screws to 8 N.m (71 lb in).