LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 811 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Knee Bolster Bracket Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the knee bolster bracket right center.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the knee bolster bracket right center screws.
    Fig 1: Knee Bolster Bracket Right Center Screws
    G01566500Courtesy of GENERAL MOTORS CORP.

    Tighten 

    Tighten the knee bolster bracket right center screws to 8 N.m (71 lb in).

  3. Install the knee bolster bracket right side. Install the knee bolster bracket right side screws.
    Fig 2: Knee Bolster Bracket Right Side Screws
    G01566501Courtesy of GENERAL MOTORS CORP.

    Tighten 

    Tighten the knee bolster bracket right side screws to 8 N.m (71 lb in).

  4. Roll the instrument panel up. Refer to INSTRUMENT PANEL (I/P) ASSEMBLY REPLACEMENT .
  5. Install the passenger's knee bolster. Refer to KNEE BOLSTER REPLACEMENT - RIGHT .