LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 807 (Transfer Case - NVG 136-NP4) >> Repair Instructions >> Transfer Case Output Shaft Seal Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the J 37668-A,  install the transfer case rear output shaft seal.
    Fig 1: Installing Transfer Case Rear Output Shaft Seal Using J 37668-A
    G01643253Courtesy of GENERAL MOTORS CORP.
  2. Install the rear propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - REAR in Propeller Shaft.
  3. Check the transfer case fluid level. Refer to TRANSFER CASE FLUID REPLACEMENT .
  4. Lower the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
scientia non olet · About LEMON Manuals