LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 807 (Transfer Case - NVG 136-NP4) >> Repair Instructions >> Transfer Case Motor/Encoder Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
  2. Remove the engine brace mounting bolt.
  3. Remove the engine brace.
    4. Fig 1: Engine Brace
    G01643227Courtesy of GENERAL MOTORS CORP.
  4. Remove the front propeller shaft. Refer to PROPELLER SHAFT REPLACEMENT - FRONT in Propeller Shaft.
  5. Remove the motor/encoder electrical connector.
    Fig 2: Motor/Encoder Electrical Connector
    G01643228Courtesy of GENERAL MOTORS CORP.
  6. Remove the motor/encoder mounting bolts.
    Fig 3: Motor/Encoder Mounting Bolts
    G01643229Courtesy of GENERAL MOTORS CORP.
  7. Remove the motor/encoder assembly.
    Fig 4: Motor/Encoder Assembly
    G01643230Courtesy of GENERAL MOTORS CORP.
  8. Remove the motor/encoder gasket.
    Fig 5: Motor/Encoder Gasket
    G01643231Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals