LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 801 (Front Suspension System) >> Repair Instructions >> Wheel Hub, Bearing, and Seal Replacement (RWD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to JACKING AND LIFTING in General Information.
  2. Remove the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  3. Remove the brake rotor. Refer to BRAKE ROTOR (FRONT) in Disc Brakes.
  4. Remove the wheel hub and bearing mounting bolts.
    Fig 1: Removing Wheel Hub And Bearing
    G01646301Courtesy of GENERAL MOTORS CORP.
  5. Remove the wheel speed sensor mounting bolt from the wheel hub and bearing.
  6. Disconnect the wheel speed sensor from the wheel hub and bearing.
    Fig 2: Disconnecting Wheel Speed Sensor
    G01646302Courtesy of GENERAL MOTORS CORP.
  7. Disengage wheel hub and bearing from steering knuckle.
  8. Remove wheel speed sensor through the access hole in the splash shield.
  9. Remove the wheel hub and bearing and splash shield.
  10. Remove the splash shield form the wheel hub and bearing.
    Fig 3: Removing Splash Shield
    G01646303Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals