LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 801 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft insulators on the stabilizer shaft. Position the slit on the insulator toward the front of the vehicle.
  2. Install the stabilizer shaft.
  3. Install the stabilizer shaft brackets over the stabilizer shaft insulators.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: Installing Stabilizer Shaft Brackets
    G01646194Courtesy of GENERAL MOTORS CORP.
  4. Install the stabilizer shaft bracket mounting bolts.

    Tighten 

    Tighten the stabilizer shaft bracket mounting bolts to 36 N.m (27 lb ft).

  5. Install the stabilizer shaft links. Refer to STABILIZER SHAFT LINK REPLACEMENT (RWD)  or STABILIZER SHAFT LINK REPLACEMENT (AWD)  .
  6. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals