LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 801 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement (AWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer shaft link insulator to the stabilizer shaft link bolt and insert the stabilizer shaft link bolt down through the stabilizer shaft.
  2. Install stabilizer shaft link to the stabilizer shaft link bolt and insert the stabilizer shaft link bolt down through the lower control arm.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the stabilizer shaft insulator and stabilizer shaft link retaining nut.

    Tighten 

    Tighten the stabilizer shaft link retaining nut to 17 N.m (13 lb ft).

  4. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
    Fig 1: Installing Stabilizer Shaft Link
    G01646204Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals