LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 801 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using a pry bar, lower the stabilizer shaft.
  2. Install the stabilizer shaft insulator to the stabilizer shaft. Position the slit on the stabilizer shaft insulator toward the front of the vehicle.
  3. Install the stabilizer shaft bracket over the stabilizer shaft insulator.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the stabilizer shaft bracket retaining bolts.

    Tighten 

    Tighten the stabilizer shaft bracket retaining bolts to 36 N.m (27 lb ft).

    Fig 1: Installing Stabilizer Shaft Bracket
    G01646206Courtesy of GENERAL MOTORS CORP.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals