LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 797 (Antilock Brake System) >> Repair Instructions >> Wheel Speed Sensor Replacement (RWD) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the WSS (5) into the hub/bearing assembly (4).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: Installing Wheel Speed Sensor (RWD)
    G01643548Courtesy of GENERAL MOTORS CORP.
  2. Install the WSS mounting bolt.

    Tighten 

    Tighten the WSS mounting bolt to 18 N.m (13 lb ft).

  3. Install the WSS cable mounting clip to the knuckle.
  4. Install the WSS cable mounting clip to the upper control arm.
  5. Install the WSS cable mounting clip to the frame attachment point.
  6. Connect the WSS cable electrical connector.
  7. Install the brake rotor (2). Refer to DISC BRAKES in Disc Brakes.
  8. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  9. Return to DIAGNOSTIC STARTING POINT - ANTILOCK BRAKE SYSTEM .
scientia non olet · About LEMON Manuals