Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
- Install the diode to the vehicle.
- Connect the electrical connector to the diode.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the screw that retains the diode to the body lock pillar.
Tighten
Tighten the screw that retains the diode to the body lock pillar to 6 N.m (53 lb in).
- Install the body side front lower trim panel. Refer to TRIM PANEL VENT REPLACE - BODY SIDE FRONT LOWER in Interior Trim.