Parking Brake Pedal: Removal
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
- Release parking brake.
- Raise vehicle.
- Loosen equalizer.
- Lower vehicle.
- Remove release handle cable and grommet from the parking brake pedal assembly.
- Depress locking tabs and remove release handle from instrument panel.
- Disconnect electrical connector from the parking brake switch.
- Remove bolts.
- Disconnect parking brake cable from the lever. The locating tab on the lever must be straightened to release the cable.
- Depress the locking tabs on the parking brake cable housing and remove cable housing from the pedal assembly.
- Remove lever assembly from vehicle.