Sensing & Diagnostic Module (SDM): Removal
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 7 under DISABLING & ACTIVATING AIR BAG SYSTEM.
- Remove driver's seat. Remove carpet retaining sill trim molding. Fold back carpet to access SDM. Remove Connector Position Assurance (CPA) clip and disconnect SDM harness connector from SDM. See Figure. Remove SDM mounting nuts. Remove SDM.