Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.

Install the ignition lock cylinder case (1) onto the steering column housing assembly.
NOTE:
Screw the 3 pan head tapping screws (2) into the ignition lock cylinder case.
Tighten

Tighten the pan head tapping screws to 7 N.m (62 lb in).

Fig 1: Installing Ignition Lock Cylinder Case
Courtesy of GENERAL MOTORS CORP.

CAUTION:
Connect the park lock cable assembly (1).
- Place the lock cylinder in the OFF-LOCK position.
- Place the gear shift lever clevis into the PARK position.
- Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.
Fig 2: Connecting Park Lock Cable Assembly
Courtesy of GENERAL MOTORS CORP.
Install the ignition switch. Refer to IGNITION SWITCH REPLACEMENT .
Install the steering column tilt head housing. Refer to STEERING COLUMN TILT HEAD HOUSING REPLACEMENT (TILT) .
Install the ignition lock cylinder. REFER TO IGNITION LOCK CYLINDER REPLACEMENT .
Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM in SIR.