Removal Procedure
WARNING: This page is about a different car, the 2003 GMC Safari and 2003 Chevrolet Astro. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Use the proper tool in order to separate all the ball joints.
- Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE in General Information.
- Remove the prevailing torque nut (5) from the connecting rod (1) ball stud.
Discard the prevailing torque nut (5).
- Use the J 24319-B in order to remove the connecting rod (1) from the relay rod (4).
- Remove the prevailing torque nut (2) from the pitman arm (3) ball stud.
Discard the prevailing torque nut (2).
- Use the J 24319-B in order to remove the connecting rod (1) from the pitman arm (3).
- Inspect the ball stud threads for damage.
- Inspect the ball stud seals for excessive wear.
- Clean the threads on the ball stud.