Test Description
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
The number below refers to the step number on the diagnostic table.
- 2: A DTC P0602 indicates the PCM is not programmed.
DTC P0601-P0607, P1600, P1621, P1627, P1680, P1681, P1683, or P2610
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check-Engine Controls? | Go to Step 2 | Go to Diagnostic System Check - Engine Controls |
| 2 | Is DTC P0602 set? | Go to Step 3 | Go to Step 5 |
| 3 | Program the PCM. Refer to Service Programming System (SPS)
in Programming. Does DTC P0602 reset? |
Go to Step 4 | Go to Step 6 |
| 4 |
|
Go to Step 5 | Go to Step 6 |
| 5 | Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement
. Did you complete the replacement? |
Go to Step 6 | - |
| 6 |
|
Go to Step 2 | Go to Step 7 |
| 7 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
Go to Diagnostic Trouble Code (DTC) List | System OK |