Under the Front Suspension Crossmember - Optional Front Location
WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Supporting Vehicle With Jack Stands - Under Front Suspension Crossmember (Optional Front Location)
Important:
- The jack stand support pads must not come in contact with the front suspension mono-leaf spring.
- Carefully observe the following:
- Be sure to place a block or pad between the jack stand support pads and the vehicle.
- Make sure the jack stand support pads span at least 2 suspension crossmember ribs (1).
- Support only in the areas shown.
Position the jack stand support pads as follows:
Spanning the 2 suspension crossmember ribs (1).