LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis (Single Page) >> Electrical >> Motors, Switches, Relays >> Wiring Systems (General Information) >> Repair Instructions >> Relay Replacement (Attached To Wire Harness) >> Removal Procedure

Removal Procedure

  1. Locate the relay. Refer to the Master Electrical Component List  to locate the relay in the vehicle.
  2. Remove any fasteners which hold the relay in place.
  3. Remove any connector position assurance (CPA) devices or secondary locks.

    Important:  Use care when removing a relay in a wiring harness when the relay is secured by fasteners or tape.

  4. Separate the relay (1) from the wire harness connector (2).
    Fig 1: Separating Relay From Wire Harness Connector
    G02505817Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals