Terminal Removal

Follow the steps below in order to repair pull-to-seat connectors.

1. Remove the terminal position assurance (TPA) device, the connector position assurance (CPA) device, and/or the secondary lock.
2. Separate the connector halves.
3. Using the proper pick or removal tool insert into the front of the connector body.
4. Grasp the wire at the back of the connector body and gently pull the terminal (1) from the connector body (3).
   Fig 1: Removing Terminal From Connector Body

   Courtesy of GENERAL MOTORS CORP.
5. Inspect the terminal for damage, if damaged refer to Terminal Repair  .
6. Reform the locking tang (2) if the terminal is being reused.