LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> General Hydraulic Brake System >> Repair Instructions >> Brake Hose Replacement - Rear >> Removal Procedure

Removal Procedure

  1. Raise the vehicle.
  2. Clean all dirt and foreign material from the brake hoses and brake pipe fitting.

    Important:  Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.

  3. Use a backup wrench on the hose fitting, disconnect the brake pipe fittings from the junction block, then cap or plug the brake pipe fitting ends. Do not bend the brake pipe or the bracket.
    Fig 1: Brake Pipe Fittings At Junction Block
    G02502292Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the brake pipe fitting (9).
  5. Remove the brake hose retaining clip (2).
  6. Remove the junction block bolt (5).
  7. Remove the rear brake hose (4).
    Fig 2: Brake Hose Replacement - Rear
    G02502293Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals