Installation Procedure
- Install the striker to the door (4). The narrow part on the wedge plate of the striker should point toward the rear of the vehicle.
- Install the insulator (3).
- Install the nuts to the striker (2). Tighten: Tighten the nuts to the striker to 30 N.m (22 lb ft).
- Install the water deflector. Refer to Water Deflector Replacement .
- Install the trim panel. Refer to TRIM PANEL REPLACEMENT - REAR DOOR (CARGO DOORS) or TRIM PANEL REPLACEMENT - REAR DOOR (E54) .
NOTE:
Refer to FASTENER NOTICE
in GM Vehicles Cautions & Notices.