LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat System >> Repair Instructions >> Seat Cushion Frame Replacement - Rear (YC5 and YC6) >> Installation Procedure

Installation Procedure

  1. Install the seat cushion frame. See Figure.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the seat back hinge bolts to the right and left sides of the seat cushion frame. See Figure.

    Tighten 

    Tighten the seat back hinge bolts to the right and left sides of the seat cushion frame 30 N.m (22 ft lbs).

  3. Install the seat cushion cover and pad. Refer to Seat Cushion Cover and Pad Replacement - Rear .
  4. Install the rear bench seat to the vehicle. Refer to Seat Replacement - Rear Bench (2001)  or Seat Replacement - Rear Bench (2002)  .
scientia non olet · About LEMON Manuals