LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Astro Van Passenger, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat System >> Repair Instructions >> Seat Back Hinge Replacement - Rear (YC5 and YC6) >> Installation Procedure

Installation Procedure

  1. Install the seat back hinge to the seat cushion frame. See Figure.
  2. Install the latch release cable to the seat back hinge.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the right and left bolts that retain the seat back hinge to the seat back frame and the seat cushion frame in the locations noted during disassembly.

    Tighten 

    Tighten the right and left bolts retaining the seat back hinge to the seat back frame and the seat cushion frame to 30 N.m (22 ft lbs).

  4. Install the right and left sides of the rear seat back hinge trim. Refer to Seat Back Hinge Trim Replacement - Rear Left  and Seat Back Hinge Trim Replacement - Rear Right (YC6)  .
  5. Install the rear bench seat to the vehicle. Refer to Seat Replacement - Rear Bench (2001)  or Seat Replacement - Rear Bench (2002)  .
scientia non olet · About LEMON Manuals