LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle Overhaul & Testing - 4T65-E >> Transaxle Disassembly >> Reverse Band Servo

Reverse Band Servo

  1. Using long screwdriver, depress reverse band servo cover by prying against holding fixture. Pry retaining ring from reverse band servo cover. See Fig 1.
  2. Remove screwdriver. Servo assembly will push servo cover up. Using small screwdriver, pull servo cover "O" ring seal out through slot in case. Cut servo "O" ring seal. Depress reverse band servo cover. Grasp one end of cut seal and pull from servo cover. Servo assembly will push servo cover up. Remove servo cover, reverse band servo assembly and reverse band servo piston return spring. See Fig 2.
Fig 1: Removing & Installing Reverse Servo Assembly Cover
G00057600Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing & Installing Reverse Servo Assembly
G00073385Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals