Accumulator Assembly & 2-1 Manual Band Servo

1. Remove accumulator cover bolts from 1-2 and 2-3 accumulator cover. See Fig 1. Remove bolts from 2-1 manual band servo cover. Using screwdriver, gently pry lube oil pipe retainer from case. See Fig 2. Remove lube oil pipe from front differential carrier internal gear lube hole. See Fig 3.
2. Remove 1-2 and 2-3 accumulator assembly and 2-1 manual band servo assembly together. Remove pipe assembly. DO NOT twist pipe assembly. Remove cover gasket from 2-1 manual band servo.

Fig 1: Removing & Installing Accumulator & 2-1 Manual Band Covers

Courtesy of GENERAL MOTORS CORP.

Fig 2: Removing & Installing Lube Oil Pipe Retainer

Courtesy of GENERAL MOTORS CORP.

Fig 3: Exploded View Of Accumulator Components & 2-1 Manual Band Servo

Courtesy of GENERAL MOTORS CORP.