LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle Overhaul & Testing - 4T65-E >> Component Disassembly & Reassembly >> Input, 2ND, 3RD & Sprag Clutches >> Reassembly

Input, 2ND, 3RD & Sprag Clutches: Reassembly

  1. Install selective thrust washer and thrust bearing assembly onto input clutch housing assembly. See Figure. Using small screwdriver, align 2nd clutch teeth. Install 2nd clutch housing assembly onto 2nd clutch hub of input clutch housing assembly.
  2. Install Final Drive/Clutch Remover/Installer (J-33381-A) into 2nd clutch housing and input clutch housing. Sprag clutch assemblies will also be attached. See Figure. Tighten threaded rod until rod is finger tight.
scientia non olet · About LEMON Manuals