Disassembly & Reassembly

Using Driver Handle (J-8092), Bearing Remover (J-34129) and hammer, drive driven sprocket support bearing from support. See Fig 1. To reassemble, position driven sprocket support bearing assembly so markings on edge of bearing are facing up. Using Driver Handle (J-8092), Bearing Installer (J-34126) and hammer, seat bearing flush to or below support hub. See Fig 2.

Fig 1: Removing Driven Sprocket Support Bearing

Courtesy of GENERAL MOTORS CORP.

Fig 2: Installing Driven Sprocket Support Bearing

Courtesy of GENERAL MOTORS CORP.