LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle -- 4T65-E - Service & Repair >> Repair Instructions >> Output Shaft Replacement (M76) >> Installation Procedure

Installation Procedure

  1. Install the drive axle retaining ring (509) and the output shaft differential inboard snap ring (512) onto the output shaft (510).
  2. Install the fourth clutch bearing (511) onto the output shaft (510).
  3. Hold the front differential carrier (700) in place and carefully install the output shaft (510) into the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
  4. Install the transfer case assembly. Refer to TRANSFER CASE ASSEMBLY REPLACEMENT
  5. Install the Engine/Transaxle assembly. Refer to ENGINE REPLACEMENT .
    Fig 1: Installing Engine/Transaxle Assembly
    G01812624Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals