LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle -- 4T65-E - Service & Repair >> Repair Instructions >> Output Shaft Replacement (M15) >> Installation Procedure

Installation Procedure

  1. Install the drive axle retaining ring (509) and the output shaft differential inboard snap ring (512) onto the output shaft (510).
  2. Install the fourth clutch bearing (511) onto the output shaft (510).
  3. Hold the front differential carrier (700) in place and carefully install the output shaft (510) into the transmission through the left wheel opening. Extend the output shaft through the differential side gear.
  4. Install the case extension housing. Refer to Case Extension Housing Replacement 
  5. Connect the left drive axle to the transaxle. Refer to WHEEL DRIVE SHAFT REPLACEMENT -- FRONT .
    Fig 1: Installing Drive Axle Retaining Ring
    G01812620Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals