LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle -- 4T65-E - Service & Repair >> Repair Instructions >> Front Wheel Drive Shaft Oil Seal Replacement - Right >> Removal Procedure

Removal Procedure

  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the right front tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  3. Remove the right engine splash shield. Refer to SPLASH SHIELD REPLACEMENT - ENGINE .
  4. Remove the right stabilizer shaft brackets from the right lower control arm. Refer to STABILIZER SHAFT LINK REPLACEMENT .
  5. Remove the right tie rod end from the right steering knuckle. Refer to TIE ROD END REPLACEMENT -- OUTER .
  6. Remove the right lower ball joint from the lower control arm. Refer to LOWER BALL JOINT REPLACEMENT .
  7. Remove the right wheel drive shaft from the transaxle. Refer to WHEEL DRIVE SHAFT REPLACEMENT -- FRONT .
  8. Secure the right wheel drive shaft to the right steering knuckle and strut.
  9. Using the J 6125-B with the J 6125-1B and the J 23129 remove the wheel drive shaft oil seal (1) from the transmission.
Fig 1: Wheel Drive Shaft Oil Seal (Right)
G01812529Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals