LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle -- 4T65-E - Service & Repair >> Repair Instructions >> Automatic Transmission Mount Inspection

Automatic Transmission Mount Inspection

NOTE: In order to avoid oil pan damage and possible engine failure, insert a block of wood that spans the width of the oil pan bottom between the oil pan and the jack support
  1. Use a jack or a utility stand to raise the transmission/transaxle in order to remove the weight from the transmission/transaxle mount and create slight tension in the mount.
  2. Inspect the transmission/transaxle mount. Replace the transmission/transaxle mount if the transmission/transaxle mount exhibits any of the following conditions:
    • The rubber surface is covered with cracks.
    • The rubber is separated from the metal plate of the mount.
    • The rubber is split through the center.
  3. If there is movement between the metal plate of the transmission/transaxle mount and the transmission, tighten the transmission mount fasteners to the correct tightening specification.

For information on the engine mount, refer to ENGINE MOUNT INSPECTION .

scientia non olet · About LEMON Manuals