Clearing Transmission Adaptive Pressure (TAP)

Updating TAP information is a learning function of the PCM designed to maintain acceptable shift times. It is not recommended that TAP information be reset unless one of the following repairs has been made:

• Transmission overhaul or replacement
• Repair or replacement of an apply or release component (clutch, band, piston, servo)
• Repair or replacement of a component or assembly which directly affects line pressure

Resetting the TAP values using a Scan Tool  will erase all learned values in all cells. As a result, the PCM will need to relearn TAP values. Transmission performance may be affected as new TAPs are learned. The PCM must also relearn TAP values when the PCM or the transmission is replaced.